MTG-5000校表儀打線機機械手表測試儀

1.儀器性能Instrument function

維時No.5000是一款精密的機械表測試儀器，用于手表制造商及鐘表維修技師對機械表進行多方面的測試。

The WEI SHI WATCH EXPERT NO.5000 is a precise mechanical watches test instrument, It is used for multi-testing by watch manufacturers and watch technician

可在液晶顯示屏上將手表頻率圖完整地顯示，并提供5種顏色選擇。會自動計算日差、擺幅及頻率錯誤，并以數據顯示。

The frequency diagram of watch can be displayed in the LCD screen, and the color can be selected in five kinds of model. The instrument will automatically calculate the rate, amplitude, beat error, and display them by data in the screen.

對常規節拍的手表，儀器會自動感應；對特殊節拍的手表，可以用手動選擇?？蛇x擇2秒、4秒、6秒、8秒、10秒、20秒、30秒、60秒的取樣周期，并計算對應周期內的平均值作為手表的計時精度值。

For the conventional beat, the instrument can automatically response;for the special beat, can manually select.

The sampling period can selected by two seconds,four seconds, six seconds, eight seconds, 10 seconds, 20 seconds, 30 seconds, 60 seconds, and the average of corresponding period will be regard as the precise value of the watch.

可調整6種測試方位，測試中模擬聲響可選擇有或無。儀器還備有時鐘顯示功能，以方便校對手表的時間。

Six kinds of test position can be set,the simulation sound can be set to audio or mute. Equipment also has its own clock display, used to facilitate checking the time of watches.

2.按鍵功能及顯示Keys and Display

2.1按鍵功能KeyFeatures

A信號↑信號增強鍵

ASignal↑Signal Increase Key

B信號↓信號減弱鍵

B Signal↓Signal Decrease Key

C時鐘時鐘調整鍵

C TimeClock adjustment Key

D聲響(揚聲器)揚聲器開/關鍵

D SpeakerSpeaker ON/OFF Key

E顏色顏色調整鍵

E ColorColor adjustment Keys

F周期取樣周期選擇鍵

FPeriodSampling period Choice Key

G升角升角調整鍵

GLift angleLift angle adjustment Key

H節拍節拍調整鍵

HBeat numberBeat adjustment Key

I數值↑選擇下一個更高數值的鍵

IValue↑Selection of the next higher value

J數值↓選擇下一個更低參數的鍵

J Value↓Selection of the next lower value

K開始/暫停手表檢測的啟/停按鍵

K Start/StopWatch test start/stop Keys

L打印打印輸出啟動鍵

L PrintPrint-out start Keys

• 參數顯示Parameters display

A日差(快慢)日差值以秒/天顯示

ARATERate deviation in seconds per day.

B擺幅 顯示擺幅的度數

B AMPLITUDEDisplay of the amplitude in degrees.

C偏振(頻率錯誤)偏振值以毫秒顯示

CBEAT ERRORDisplay of the beat error in ms.

D顏色顯示當前的顏色狀況

DCOLORDisplay the status of present color

E信號顯示感應信號的強度

ESIGNALDisplay signal strength of the sensor

F時鐘顯示當?shù)貥?biāo)準時間

F TIMEDisplay the local standard time

G聲響顯示有聲或者無聲

G SPEAKERDisplay sound or mute

H周期顯示測試的取樣周期

H PERIODDisplay Sampling period of tested watch

I升角顯示所選升角的度數

ILIFT ANGLEDisplay the selected lift angle of escapement

J節拍顯示所測節拍為自動選擇或手動選擇

JBEATDisplay the measured beat is automatic or manual

2.3連接CONNECTION

A感應連接口ASensor connector

B電源開關BPower Switch

C打印機連接口CPrinter port

D電源輸入接口(適用于100 V～240V交流電源)

DPower Supply Connector （adaptation range 100 V～240V AC）

E頻率校準接口(本公司的工程師才可以校準)

EFrequency calibration Connector （the company's engineers can only be calibrated）

3.安裝INSTALLATION

• 儀器的基本組件The basic equipment components

測試儀器主機Testing equipment host

感應器Microphone

電源線Power cable

產品說明書Instruction

• 設備的安裝EquipmentInstallation

注意：

儀器不能安裝在陽光直射或溫度超出60℃的地方。感應器應與嘈雜的機械聲、喇叭聲、脆的物品敲打聲,特別象超聲波清洗機等要保持有足夠的距離，嘈雜的聲音會干擾感應信號的輸入,如果儀器裝有打印機，也應保持足夠的距離。

MTG-5000校表儀打線機機械手表測試儀

MTG-5000

MTG5000